Twin Bench Top Water Filter Installation – Fluoride Ceramic/Carbon (Cerametix) and Sediment (1025PS0.5) Filters

3 11/08/2024

Installation Instructions

  1. Remove the aerator screen from the tap spout by unscrewing.
  2. If your spout has an external thread then the diverter valve will screw straight onto it.
    If your spout has an internal thread then simply screw the threaded adaptor supplied into the spout before attaching the diverter valve.
  3. When the lever is straight down this allows you to run hot & cold water for washing up.
  4. To produce purified water simply turn on the cold water tap then turn the lever across, this diverters the water through the filter and out the filter spout.
  5. Follow flushing instructions (below) before use

Flushing of new filters

NOTE: The Ceramic filter should be washed down before installing by soaking in cold water and wiping the outside of the cartridge.

Do not touch the ceramic surface before soaking as oils from your skin can impair the surface performance of the filter. 

The ceramic filter must be installed with the blanked off end at the bottom of the filter sump.

Ceramic filters can be cleaned by using a scouring pad once flow starts to reduce over time.

  1. Fit the Filters in the correct order into the housing.
  2. Turn on the new sink tap and leave on.
  3. Flush the new fluoride filter for 3 – 4 min.
  4. Turn off sink tap and check for leaks.

As the filters are so fine you may have some air bubbles in the water for a few days, this will go away.

  • Always lubricate the housing o-ring, a little veggie oil will do.
  • Invert system when changing filters (place upside-down and unscrew sumps)
  • When upside-down the Fluoride Filter is placed upright into the sump
  • Tighten the housing by hand only, as they get tight after use.
  • Never filter hot water.
  • Maximum filter life is 12 months (Fluoride removal effective capacity is 2,000L).

Your replacement filters can be purchased from Clarence Water Filters.

Stage I           1025PS0.5                PolySpun Sediment Filter 0.5 micron

Stage II          1025Cerametix        Fluoride Ceramic + Carbon Filter 0.2 micron

CLARENCE WATER FILTERS

W:  www.clarencewaterfilters.com.au             

T:  02 6646 8565               

E:  sales@clarencewaterfilters.com.au